An offset h must be introduced into a metal tube - id0750085996398 от hanny13 31.08.2020 22:40

Question

Engineering: An offset h must be introduced into a metal tube of 0.75-in. outer diameter and 0.08-in. wall thickness. Knowing that the maximum stress after the offset is introduced must not exceed 3 times the stress in the tube when it is straight, determine the largest offset that can be used.

hanny13 · Accepted Answer

Hello your question is incomplete attached below is the complete question

answer :

Attached below

Explanation:

Given data:

The inputs of two registers are controlled by a 2-to-1 multiplexer.

The multiplexer select line and the register load enable inputs are controlled by inputs Co, C1, and C2.

Using the required transfers in the question to complete the detailed logic diagrams ( attached below )

The inputs of two registers R0 and R1 are controlled by a 2-to-1 multiplexer. The multiplexer select

An offset h must be introduced into a metal tube of 0.75-in. outer diameter and

Popular Questions about the subject: Engineering

New questions by subject

We expand our knowledge with many expert answers